3diy
/
moonraker
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity

Updated documentation with Tasmota power configuration settings and sample 

Signed-off-by: Matthias Neumayr <matt.neumayr@gmail.com>
This commit is contained in:
Matthias Neumayr 2020-11-21 12:14:57 +01:00 committed by Eric Callahan
parent 6ba54d9cb1
commit 4415a3c858
1 changed files with 17 additions and 4 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

21
docs/installation.md
View File

@ -265,10 +265,10 @@ a printer on/off regardless of Klippy's state. GPIOs are toggled
using libgpiod. A configuration section should be added for each using libgpiod. A configuration section should be added for each
device as shown below: device as shown below:
``` ```
[power device name] [power device_name]
type: gpio type: gpio
# The type of device. Can be either gpio or tplink_smartplug. This # The type of device. Can be either gpio, tplink_smartplug or tasmota.
# parameter must be provided. # This parameter must be provided.
pin: gpiochip0/gpio26 pin: gpiochip0/gpio26
# The pin to use for GPIO devices. The chip is optional, if left out # The pin to use for GPIO devices. The chip is optional, if left out
# then the module will default to gpiochip0. If one wishes to invert # then the module will default to gpiochip0. If one wishes to invert
@ -283,7 +283,15 @@ port:
# The above options are used for "tplink_smartplug" devices. The # The above options are used for "tplink_smartplug" devices. The
# address should be a valid ip or hostname for the tplink device. # address should be a valid ip or hostname for the tplink device.
# The port should be the port the device is configured to use. The # The port should be the port the device is configured to use. The
# address must be provided. The port defaults to 9999. # address must be provided. The port defaults to 9999.
address:
password:
output_id:
# The above options are used for "tasmota" devices. The
# address should be a valid ip or hostname for the tasmota device.
# Provide a password if configured in Tasmota (default is empty).
# Provided an output_id (relay id) if the Tasmota device supports
# more than one (default is 1).
``` ```
Below are some potential examples: Below are some potential examples:
@ -299,6 +307,11 @@ pin: !gpiochip0/gpio16
[power wifi_switch] [power wifi_switch]
type: tplink_smartplug type: tplink_smartplug
address: 192.168.1.123 address: 192.168.1.123
[power tasmota_plug]
type: tasmota
address: 192.168.1.124
password: password1
``` ```
It is possible to toggle device power from the Klippy host, this can be done It is possible to toggle device power from the Klippy host, this can be done