diff --git a/hw.cfg b/hw.cfg
index ff0813a..898de0e 100644
--- a/hw.cfg
+++ b/hw.cfg
@@ -75,16 +75,19 @@ pressure_advance = 0.04
 [filament_switch_sensor filament_sensor]
 pause_on_runout: False
 runout_gcode:
-  M117 Out of Filament
-  #positions here are in printer coordinates eg if you have a 300mm bed and your sensor is 7cm past the 
-  #max y position then y_offset should be 370
-  #{% set x_offset = 150 %}  #approximate x location of the runout sensor
-  #{% set y_offset = 370 %}    #approximate y location of the runout sensor
-  #z location not used but this can be easily extended to include a z offset if needed
-  #{% set current_x = printer.toolhead.position.x %}
-  #{% set current_y = printer.toolhead.position.y %}
-  #{% set distance = ((x_offset - current_x)**2 + (y_offset - current_y)**2)**(1/2) %}
-  PAUSE_AFTER_D D=640
+  M600
+
+#runout_gcode:
+#  #M117 Out of Filament
+#  #positions here are in printer coordinates eg if you have a 300mm bed and your sensor is 7cm past the 
+#  #max y position then y_offset should be 370
+#  #{% set x_offset = 150 %}  #approximate x location of the runout sensor
+#  #{% set y_offset = 370 %}    #approximate y location of the runout sensor
+#  #z location not used but this can be easily extended to include a z offset if needed
+#  #{% set current_x = printer.toolhead.position.x %}
+#  #{% set current_y = printer.toolhead.position.y %}
+#  #{% set distance = ((x_offset - current_x)**2 + (y_offset - current_y)**2)**(1/2) %}
+#  #PAUSE_AFTER_D D=640
 # insert_gcode:
 #  M117 Resuming
 #  M602