75d5737211
Add a fully functional STM32F1 port, currently mostly targeting STM32F103 microcontrollers. This requires an 8 MHz XTAL. The maximum possible step rate is around 282K steps per second. This uses stm32flash to burn the firmware. The bootloader needs to be started by setting BOOT0 to 1 and resetting the MCU. There is no automatic bootloader, unlike on Arduino. Signed-off-by: Grigori Goronzy <greg@kinoho.net> |
||
|---|---|---|
| .. | ||
| cmsis_gcc.h | ||
| core_cm3.h | ||
| core_cmFunc.h | ||
| core_cmInstr.h | ||