e6ef48cdf7
Fix filament sensor and remove unneeded config changes in extruder The filament sensor on the printer used for initial testing had been removed prior to flashing klipper to it. Only a basic test to see it if triggered or not was preformed. It was discovered by someone else doing some testing on another printer that it would frequently pause. This was a simple oversight, assuming it was a runout switch. Removed section of config related to filament runout switch and replaced with basic config for filament motion so they printer will simply pause when no more motion is detected. Also notated to add CLEAR_PAUSE to start gcode if using this sensor as it will trigger a paused state when loading or unloading filament. If printer is in a paused state at the start of the print, the attempt to pause will cause the printer to rapidly pause and unpause itself. Removed min_extruder_temp and max_extrude_only_distance from the extruder section, as they were there only for macros on a test system that is not put into this sample config Signed-off-by: Zachary Welvaert <zwelvaert@gmail.com> |
||
|---|---|---|
| .github | ||
| config | ||
| docs | ||
| klippy | ||
| lib | ||
| scripts | ||
| src | ||
| test | ||
| .gitignore | ||
| COPYING | ||
| Makefile | ||
| README.md | ||
README.md
Welcome to the Klipper project!
Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.
To begin using Klipper start by installing it.
Klipper is Free Software. See the license or read the documentation. We depend on the generous support from our sponsors.