klipper

Клиппер

Go to file

Kevin O'Connor d9f6abdb56 canbus: Move high-level CAN code to new src/generic/canbus.c Separate out the high-level command processing logic from the low-level transmission code. Place the high-level code in src/generic/canbus.c . This also removes the CAN dependency on serial_irq.c . Signed-off-by: Kevin O'Connor <kevin@koconnor.net>		2021-02-02 15:24:11 -05:00
.github/workflows	workflows: Update stale-issue-bot.yaml to also close invalid tickets	2021-02-02 13:22:35 -05:00
config	test: Add printer-creality-cr6se-2020.cfg to printers.test	2021-01-24 10:54:31 -05:00
docs	ds18b20: new module for 1-wire temperature sensor (#3462 )	2021-02-02 14:34:56 -05:00
klippy	ds18b20: new module for 1-wire temperature sensor (#3462 )	2021-02-02 14:34:56 -05:00
lib	kconfiglib: Update README with info on kconfiglib modifications	2020-11-23 10:17:48 -05:00
scripts	scripts: Remove python-virtualenv from install scripts on debian type distros	2021-01-24 11:32:09 -05:00
src	canbus: Move high-level CAN code to new src/generic/canbus.c	2021-02-02 15:24:11 -05:00
test	test: Add printer-creality-cr6se-2020.cfg to printers.test	2021-01-24 10:54:31 -05:00
.gitignore	util: Fix versioning when gitdir is absent (#809 )	2018-10-27 10:44:38 -04:00
COPYING	Initial commit of source code.	2016-05-25 11:37:40 -04:00
Makefile	Makefile: Improve build when changing micro-controller architecture	2020-12-17 10:02:16 -05:00
README.md	docs: Update main README file to point to website	2019-04-20 13:43:35 -04:00

README.md

Welcome to the Klipper project!

https://www.klipper3d.org/

Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.

To begin using Klipper start by installing it.

Klipper is Free Software. See the license or read the documentation.