52 lines
1.2 KiB
Plaintext
52 lines
1.2 KiB
Plaintext
# Main Kconfig settings
|
|
|
|
mainmenu "Klipper Firmware Configuration"
|
|
|
|
choice
|
|
prompt "Micro-controller Architecture"
|
|
config MACH_AVR
|
|
bool "Atmega AVR"
|
|
config MACH_SAM3X8E
|
|
bool "SAM3x8e (Arduino Due)"
|
|
config MACH_PRU
|
|
bool "Beaglebone PRU"
|
|
config MACH_LINUX
|
|
bool "Linux process"
|
|
config MACH_SIMU
|
|
bool "Host simulator"
|
|
endchoice
|
|
|
|
source "src/avr/Kconfig"
|
|
source "src/sam3x8e/Kconfig"
|
|
source "src/pru/Kconfig"
|
|
source "src/linux/Kconfig"
|
|
source "src/simulator/Kconfig"
|
|
|
|
# The HAVE_GPIO_x options allow boards to disable support for some
|
|
# commands if the hardware does not support the feature.
|
|
config HAVE_GPIO
|
|
bool
|
|
default n
|
|
config HAVE_GPIO_ADC
|
|
bool
|
|
default n
|
|
config HAVE_GPIO_SPI
|
|
bool
|
|
default n
|
|
config HAVE_GPIO_HARD_PWM
|
|
bool
|
|
default n
|
|
|
|
config NO_UNSTEP_DELAY
|
|
# Slow micro-controllers do not require a delay before returning a
|
|
# stepper step pin to its default level. A board can enable this
|
|
# option to optimize the stepper_event() handler in this case.
|
|
bool
|
|
default n
|
|
|
|
config INLINE_STEPPER_HACK
|
|
# Enables gcc to inline stepper_event() into the main timer irq handler
|
|
bool
|
|
depends on HAVE_GPIO
|
|
default y
|