klipper

Клиппер

Go to file

TheBugLebowsky 9f4a0dc77f config: Modify printer-tronxy-x5sa-pro-2020.cfg (#4330 ) Invert filament_switch_sensor switch_pin Signed-off-by: Morgan Barresi <morganfw@gmail.com>		2021-06-02 10:48:24 -04:00
.github	workflows: Minor wording change to invalid-label-bot	2021-05-17 10:31:03 -04:00
config	config: Modify printer-tronxy-x5sa-pro-2020.cfg (#4330 )	2021-06-02 10:48:24 -04:00
docs	stepper: Remove set_tag_position() code	2021-05-29 21:54:34 -04:00
klippy	gcode: Update gcode descriptions (#4335 )	2021-06-02 10:45:27 -04:00
lib	lpc176x: Use full peripheral clock speed; fix UART interface	2021-05-04 20:29:48 -04:00
scripts	spi_flash: Add board definitions for Fysetc S6 and Spider	2021-05-03 14:36:18 -04:00
src	Revert "linux: Raise an error if configuring a pullup when that is not supported"	2021-05-27 11:33:24 -04:00
test	loop_sdcard: Add loopable SD card file sections	2021-05-26 11:57:57 -04:00
.gitignore	…
COPYING	…
Makefile	Makefile: Use CURDIR instead of PWD	2021-05-19 23:49:50 -04:00
README.md	…

README.md

Welcome to the Klipper project!

https://www.klipper3d.org/

Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.

To begin using Klipper start by installing it.

Klipper is Free Software. See the license or read the documentation.