Kevin O'Connor 99f96f2832 bltouch: Use pin_down mode for probing ... The BLTouch is more accurate when probing in "pin_down" mode than "touch_mode" (at least on some hardware). Rework the code to use that mode. When probing in pin_down mode, the BLTouch can go into an error state if a pin_up is not sent immediately after a touch signal. Rework the pin_up code to reduce the time it takes to transmit the command. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>		2019-01-21 09:52:11 -05:00
..
chelper	winch: Add experimental support for cable winch kinematics	2018-12-24 11:38:59 -05:00
extras	bltouch: Use pin_down mode for probing	2019-01-21 09:52:11 -05:00
kinematics	heater: take a gcode_id when setting up a heater (#1028)	2019-01-02 17:44:02 -05:00
clocksync.py	clocksync: Simplify is_active() check	2018-05-31 18:20:30 -04:00
configfile.py	configfile: Strip trailing comments	2018-10-16 11:45:20 -04:00
console.py	console: Try to improve the description of the SUPPRESS command	2018-11-16 17:16:14 -05:00
gcode.py	klippy: Convert printer_state("ready") to an event handler	2019-01-08 10:59:43 -05:00
heater.py	heater: take a gcode_id when setting up a heater (#1028)	2019-01-02 17:44:02 -05:00
homing.py	bltouch: Verify probe always deploys during a homing operation	2019-01-21 09:52:11 -05:00
klippy.py	klippy: Report the first error generated	2019-01-11 12:41:55 -05:00
mathutil.py	delta_calibrate: Perform coordinate descent in a background process	2018-10-15 19:01:19 -04:00
mcu.py	mcu: Fix timing of endstop checking	2019-01-10 12:27:56 -05:00
msgproto.py	msgproto: Add support for a get_constant_int() method	2018-05-28 10:43:40 -04:00
parsedump.py	…
pins.py	sam3: Add support for sam4s8c chips	2019-01-07 19:34:31 -05:00
queuelogger.py	…
reactor.py	reactor: support for delayed callbacks	2019-01-07 21:38:36 -05:00
serialhdl.py	serialqueue: Limit message transmission to available receive buffer size	2018-05-28 11:12:30 -04:00
stepper.py	endstop_phase: Move endstop phase homing code to new "extras" module	2018-10-16 13:09:23 -04:00
toolhead.py	klippy: Convert printer_state("shutdown") to an event handler	2019-01-08 10:59:43 -05:00
util.py	util: Don't crash when calling get_cpu_info on OS X (#1102)	2019-01-11 13:00:44 -05:00