klipper

Клиппер

Go to file

Kevin O'Connor 95eb00740b stm32: Avoid read+write modify instructions in can.c Prefer explicitly setting the hardware registers and avoid using C read and modify instructions where possible. This avoids race conditions where an interrupt or hardware change could cause subtle corruption of the register state. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>		2021-02-02 15:17:14 -05:00
.github/workflows	workflows: Update stale-issue-bot.yaml to also close invalid tickets	2021-02-02 13:22:35 -05:00
config	test: Add printer-creality-cr6se-2020.cfg to printers.test	2021-01-24 10:54:31 -05:00
docs	ds18b20: new module for 1-wire temperature sensor (#3462 )	2021-02-02 14:34:56 -05:00
klippy	ds18b20: new module for 1-wire temperature sensor (#3462 )	2021-02-02 14:34:56 -05:00
lib	kconfiglib: Update README with info on kconfiglib modifications	2020-11-23 10:17:48 -05:00
scripts	scripts: Remove python-virtualenv from install scripts on debian type distros	2021-01-24 11:32:09 -05:00
src	stm32: Avoid read+write modify instructions in can.c	2021-02-02 15:17:14 -05:00
test	test: Add printer-creality-cr6se-2020.cfg to printers.test	2021-01-24 10:54:31 -05:00
.gitignore	util: Fix versioning when gitdir is absent (#809 )	2018-10-27 10:44:38 -04:00
COPYING	Initial commit of source code.	2016-05-25 11:37:40 -04:00
Makefile	Makefile: Improve build when changing micro-controller architecture	2020-12-17 10:02:16 -05:00
README.md	docs: Update main README file to point to website	2019-04-20 13:43:35 -04:00

README.md

Welcome to the Klipper project!

https://www.klipper3d.org/

Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.

To begin using Klipper start by installing it.

Klipper is Free Software. See the license or read the documentation.