klipper

Клиппер

Go to file

Kevin O'Connor 93b9a85d19 endstop_phase: Add support for reporting phase information via get_status() Signed-off-by: Kevin O'Connor <kevin@koconnor.net>		2021-06-03 22:27:30 -04:00
.github	workflows: Minor wording change to invalid-label-bot	2021-05-17 10:31:03 -04:00
config	config: Modify printer-tronxy-x5sa-pro-2020.cfg (#4330 )	2021-06-02 10:48:24 -04:00
docs	endstop_phase: Add support for reporting phase information via get_status()	2021-06-03 22:27:30 -04:00
klippy	endstop_phase: Add support for reporting phase information via get_status()	2021-06-03 22:27:30 -04:00
lib	lpc176x: Use full peripheral clock speed; fix UART interface	2021-05-04 20:29:48 -04:00
scripts	spi_flash: Add board definitions for Fysetc S6 and Spider	2021-05-03 14:36:18 -04:00
src	Revert "linux: Raise an error if configuring a pullup when that is not supported"	2021-05-27 11:33:24 -04:00
test	loop_sdcard: Add loopable SD card file sections	2021-05-26 11:57:57 -04:00
.gitignore	util: Fix versioning when gitdir is absent (#809 )	2018-10-27 10:44:38 -04:00
COPYING	Initial commit of source code.	2016-05-25 11:37:40 -04:00
Makefile	Makefile: Use CURDIR instead of PWD	2021-05-19 23:49:50 -04:00
README.md	docs: Update main README file to point to website	2019-04-20 13:43:35 -04:00

README.md

Welcome to the Klipper project!

https://www.klipper3d.org/

Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.

To begin using Klipper start by installing it.

Klipper is Free Software. See the license or read the documentation.