klipper

Клиппер

Go to file

Matthew Lloyd 93add3a095 config: Add printer-fokoos-odin5-f3.cfg (#4286 ) Signed-off-by: Matthew Lloyd <github@matthewlloyd.net>		2021-05-12 15:00:06 -04:00
.github	invalid-label-bot: Minor changes to invalid label comment	2021-05-06 14:29:31 -04:00
config	config: Add printer-fokoos-odin5-f3.cfg (#4286 )	2021-05-12 15:00:06 -04:00
docs	filament_motion_sensor: add get_status (#4281 )	2021-05-11 13:17:22 -04:00
klippy	filament_motion_sensor: add get_status (#4281 )	2021-05-11 13:17:22 -04:00
lib	lpc176x: Use full peripheral clock speed; fix UART interface	2021-05-04 20:29:48 -04:00
scripts	spi_flash: Add board definitions for Fysetc S6 and Spider	2021-05-03 14:36:18 -04:00
src	debugcmds: Remove start/end_group commands	2021-05-07 13:53:47 -04:00
test	config: Add printer-fokoos-odin5-f3.cfg (#4286 )	2021-05-12 15:00:06 -04:00
.gitignore	util: Fix versioning when gitdir is absent (#809 )	2018-10-27 10:44:38 -04:00
COPYING	Initial commit of source code.	2016-05-25 11:37:40 -04:00
Makefile	Makefile: Improve build when changing micro-controller architecture	2020-12-17 10:02:16 -05:00
README.md	docs: Update main README file to point to website	2019-04-20 13:43:35 -04:00

README.md

Welcome to the Klipper project!

https://www.klipper3d.org/

Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.

To begin using Klipper start by installing it.

Klipper is Free Software. See the license or read the documentation.