klipper

Клиппер

Go to file

Kevin O'Connor 7a74888b43 toolhead: Extend flushing slightly past required time There is no harm in enabling flushing for a little longer than necessary. In contrast, a slight rounding issue causing a message to not get flushed properly could result in an error. So, extend the flushing time slightly to avoid potential issues. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>		2024-01-17 11:28:42 -05:00
.github	github: Temporarily disable close_reviewer_needed automation	2023-12-05 17:57:11 -05:00
config	config: I3DBEEZ9 New board (#6447 )	2024-01-02 11:31:30 -05:00
docs	docs: Update Multi_MCU_Homing.md to note the importance of low-latency	2024-01-16 14:19:11 -05:00
klippy	toolhead: Extend flushing slightly past required time	2024-01-17 11:28:42 -05:00
lib	lib: Update to latest can2040 code	2023-10-03 23:24:18 -04:00
scripts	spi_flash: Update board_defs.py (#6318 )	2023-08-15 14:11:51 -04:00
src	sensor_mpu9250: Check for overflows on each query_mpu9250_status command	2024-01-07 11:59:59 -05:00
test	config: I3DBEEZ9 New board (#6447 )	2024-01-02 11:31:30 -05:00
.gitignore	util: Fix versioning when gitdir is absent (#809 )	2018-10-27 10:44:38 -04:00
COPYING	COPYING: Update GPLv3 license to latest text (uses https instead of http)	2022-06-03 11:28:44 -04:00
Makefile	makefile: disable null pointer checks	2022-06-08 12:17:12 -04:00
README.md	docs: Add a Sponsors.md file	2022-07-16 10:48:10 -04:00

README.md

Welcome to the Klipper project!

https://www.klipper3d.org/

Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.

To begin using Klipper start by installing it.

Klipper is Free Software. See the license or read the documentation. We depend on the generous support from our sponsors.