Kevin O'Connor 5d26c2a08e gcode_arcs: Add back in support for E moves in absolute extrude mode ... This reverts commit 43fa41c1af. The above commit disabled absolute extrude moves because it was unclear if the code would work properly when an M221 extrude factor or G92 offset was in use. However, since the calculation is done relative to the raw E position and is sent as a raw E position to gcode.cmd_G1() these modes should not matter. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>		2020-06-04 15:25:17 -04:00
..
chelper	itersolve: Use more explicit list traversal in itersolve_generate_steps()	2020-05-04 14:00:53 -04:00
extras	gcode_arcs: Add back in support for E moves in absolute extrude mode	2020-06-04 15:25:17 -04:00
kinematics	klippy: Rename try_load_module() to load_object()	2020-05-08 11:05:14 -04:00
clocksync.py	clocksync: Don't filter any of the initial syncronization clock messages	2020-05-02 11:08:02 -04:00
configfile.py	configfile: Fix check for unused config sections and options	2020-05-21 17:50:51 -04:00
console.py	…
gcode.py	gcode: Make it clear that gcode.get_status() can be called without eventtime	2020-05-26 14:59:15 -04:00
homing.py	homing: Avoid divide by zero error on PROBE at minimum Z position	2020-04-19 12:46:50 -04:00
klippy.py	klippy: Rename try_load_module() to load_object()	2020-05-08 11:05:14 -04:00
mathutil.py	mathutil: Disable queuelogger in background_coordinate_descent()	2019-12-17 09:51:45 -05:00
mcu.py	serial: Add Fysetc Cheetah board specific reset sequence	2020-04-02 13:56:50 -04:00
msgproto.py	msgproto: unresolved symbol fixed	2019-11-15 11:36:54 -05:00
parsedump.py	…
pins.py	stepper: Move MCU_stepper from mcu.py to stepper.py	2019-11-12 17:32:18 -05:00
queuelogger.py	mathutil: Disable queuelogger in background_coordinate_descent()	2019-12-17 09:51:45 -05:00
reactor.py	reactor: Support multiple waiting timers on a single completion	2020-02-19 10:49:56 -05:00
serialhdl.py	serial: Add Fysetc Cheetah board specific reset sequence	2020-04-02 13:56:50 -04:00
stepper.py	klippy: Rename try_load_module() to load_object()	2020-05-08 11:05:14 -04:00
toolhead.py	toolhead: Handle flush_step_generation() call after dwell()	2020-06-01 15:29:20 -04:00
util.py	util: Try to dump mcu build information on a connection error	2020-03-22 13:22:52 -04:00