..
chelper
winch: Add experimental support for cable winch kinematics
2018-12-24 11:38:59 -05:00
extras
menu: Fix filament loading and unloading feature ( #1082 )
2019-01-07 10:25:19 -05:00
kinematics
heater: take a gcode_id when setting up a heater ( #1028 )
2019-01-02 17:44:02 -05:00
clocksync.py
clocksync: Simplify is_active() check
2018-05-31 18:20:30 -04:00
configfile.py
configfile: Strip trailing comments
2018-10-16 11:45:20 -04:00
console.py
console: Try to improve the description of the SUPPRESS command
2018-11-16 17:16:14 -05:00
gcode.py
respond: An extra for sending messages to the printer host. ( #1053 )
2019-01-02 17:45:35 -05:00
heater.py
heater: take a gcode_id when setting up a heater ( #1028 )
2019-01-02 17:44:02 -05:00
homing.py
endstop_phase: Move endstop phase homing code to new "extras" module
2018-10-16 13:09:23 -04:00
klippy.py
klippy: No need to return anything from _connect() method
2018-10-18 15:58:52 -04:00
mathutil.py
delta_calibrate: Perform coordinate descent in a background process
2018-10-15 19:01:19 -04:00
mcu.py
mcu: Allow set_stepper_kinematics() to set the kinematics back to None
2018-12-24 11:42:13 -05:00
msgproto.py
…
parsedump.py
…
pins.py
bus: Don't raise a "duplicate pin" warning on None pins
2019-01-02 17:37:39 -05:00
queuelogger.py
…
reactor.py
reactor: Add ability to register callbacks
2018-06-30 14:13:47 -04:00
serialhdl.py
serialqueue: Limit message transmission to available receive buffer size
2018-05-28 11:12:30 -04:00
stepper.py
endstop_phase: Move endstop phase homing code to new "extras" module
2018-10-16 13:09:23 -04:00
toolhead.py
toolhead: Do not apply main printer accel/velocity to extrude only moves
2019-01-04 12:47:45 -05:00
util.py
util: Fix versioning when gitdir is absent ( #809 )
2018-10-27 10:44:38 -04:00
6ccc0732c1