64097cb0d0
The Lulzbot TAZ6 single extruder configuration had an XY position for z homing that did not match the factory firmware, and was off center enough to cause the extruder to crash into the home button trim sometimes when homing. This commit changes the printer config so that the XY position for Z homing matches the original Marlin firmware for this printer. The Lulzbot TAZ6 single extruder configuration had an bed_tilt points that did not match the factory firmware, and were off enough that the nozzle (used for probing on this printer) could slip off the edge of the probe point or miss it entirely. This commit changes the printer config so that the coordinates for bed_tilt calibration match the original Marlin firmware for this printer. For the Lulzbot TAZ6 single extruder config, use 'gear_ratio' and 'rotation_distance' to configure the extruder. The rotation distance is based on effective circumference of the hobbed bolt based on the original Marlin firmware for the TAZ6 single-extruder, and the gear ratio was determined by simply counting the number of teeth on the pinion and spur gears. Signed-off-by: Steven T. Snyder <github@steventsnyder.com> |
||
|---|---|---|
| .github/workflows | ||
| config | ||
| docs | ||
| klippy | ||
| lib | ||
| scripts | ||
| src | ||
| test | ||
| .gitignore | ||
| COPYING | ||
| Makefile | ||
| README.md | ||
README.md
Welcome to the Klipper project!
Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.
To begin using Klipper start by installing it.
Klipper is Free Software. See the license or read the documentation.