klipper

Клиппер

Go to file

Dmitry Butyugin 57494458f3 shaper_calibrate: Ignore vibrations below max_psd / 20 threshold The input shaper can only reduce vibrations by 20x. Therefore, the best-case achievable vibrations level is max(psd) / 20. Any vibrations below that level can be ignored for the prupose of input shaper scoring. This allows tuning script to ignore wide tails of resonances, because it is not helpful to try to reduce them with input shaping. Signed-off-by: Dmitry Butyugin <dmbutyugin@google.com>		2021-03-20 13:24:43 -04:00
.github/workflows	workflows: Update stale-issue-bot.yaml to also close invalid tickets	2021-02-02 13:22:35 -05:00
config	stm32: Simplify USB/Serial/CANbus Kconfig selection	2021-03-18 13:33:33 -04:00
docs	docs: Update TMC_Drivers.md with note on SPI failures on TMC driver checks	2021-03-16 14:49:29 -04:00
klippy	shaper_calibrate: Ignore vibrations below max_psd / 20 threshold	2021-03-20 13:24:43 -04:00
lib	lib: add FatFS notes to README	2021-02-05 19:37:56 -05:00
scripts	calibrate_shaper: Use fixed 5 Hz steps for minor ticks in the charts	2021-03-20 13:24:43 -04:00
src	ds18b20: Segmentation fault on 64bit Raspberry Pi	2021-03-19 11:18:51 -04:00
test	stm32: Simplify USB/Serial/CANbus Kconfig selection	2021-03-18 13:33:33 -04:00
.gitignore	util: Fix versioning when gitdir is absent (#809 )	2018-10-27 10:44:38 -04:00
COPYING	Initial commit of source code.	2016-05-25 11:37:40 -04:00
Makefile	Makefile: Improve build when changing micro-controller architecture	2020-12-17 10:02:16 -05:00
README.md	docs: Update main README file to point to website	2019-04-20 13:43:35 -04:00

README.md

Welcome to the Klipper project!

https://www.klipper3d.org/

Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.

To begin using Klipper start by installing it.

Klipper is Free Software. See the license or read the documentation.