Клиппер
Go to file
Kevin O'Connor 55be26097f config: Minor indentation changes to skr configs
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
2021-06-01 11:28:07 -04:00
.github workflows: Minor wording change to invalid-label-bot 2021-05-17 10:31:03 -04:00
config config: Minor indentation changes to skr configs 2021-06-01 11:28:07 -04:00
docs stepper: Remove set_tag_position() code 2021-05-29 21:54:34 -04:00
klippy stepper: Remove set_tag_position() code 2021-05-29 21:54:34 -04:00
lib lpc176x: Use full peripheral clock speed; fix UART interface 2021-05-04 20:29:48 -04:00
scripts spi_flash: Add board definitions for Fysetc S6 and Spider 2021-05-03 14:36:18 -04:00
src Revert "linux: Raise an error if configuring a pullup when that is not supported" 2021-05-27 11:33:24 -04:00
test loop_sdcard: Add loopable SD card file sections 2021-05-26 11:57:57 -04:00
.gitignore util: Fix versioning when gitdir is absent (#809) 2018-10-27 10:44:38 -04:00
COPYING Initial commit of source code. 2016-05-25 11:37:40 -04:00
Makefile Makefile: Use CURDIR instead of PWD 2021-05-19 23:49:50 -04:00
README.md docs: Update main README file to point to website 2019-04-20 13:43:35 -04:00

README.md

Welcome to the Klipper project!

Klipper

https://www.klipper3d.org/

Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.

To begin using Klipper start by installing it.

Klipper is Free Software. See the license or read the documentation.