klipper

Клиппер

Go to file

Eric Callahan 4dfe01a2cd bed_mesh: move the "fade offset" out of the ZMesh This is a temporary offset applied to the mesh used to fade toward a "target". For clarity, apply the fade offset when the final z calculation is made. SIgned-off-by: Eric Callahan <arksine.code@gmail.com>		2021-06-08 00:02:35 -04:00
.github	workflows: Minor wording change to invalid-label-bot	2021-05-17 10:31:03 -04:00
config	config: Add motor power definition to generic-bigtreetech-skr-2.cfg	2021-06-07 21:38:19 -04:00
docs	resonance_tester: Set max_accel ignoring the limit from the config (#4174 )	2021-06-06 13:04:53 -04:00
klippy	bed_mesh: move the "fade offset" out of the ZMesh	2021-06-08 00:02:35 -04:00
lib	lpc176x: Use full peripheral clock speed; fix UART interface	2021-05-04 20:29:48 -04:00
scripts	spi_flash: Add board definitions for Fysetc S6 and Spider	2021-05-03 14:36:18 -04:00
src	atsamd: Add support for 25Mhz crystals	2021-06-04 17:48:21 -04:00
test	config: Add generic-duet3-mini.cfg	2021-06-04 17:48:21 -04:00
.gitignore	util: Fix versioning when gitdir is absent (#809 )	2018-10-27 10:44:38 -04:00
COPYING	Initial commit of source code.	2016-05-25 11:37:40 -04:00
Makefile	Makefile: Use CURDIR instead of PWD	2021-05-19 23:49:50 -04:00
README.md	docs: Update main README file to point to website	2019-04-20 13:43:35 -04:00

README.md

Welcome to the Klipper project!

https://www.klipper3d.org/

Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.

To begin using Klipper start by installing it.

Klipper is Free Software. See the license or read the documentation.