447125faae
Klipper logs an error on a failed CANbus write. Unfortunately, if the bus becomes permanently disabled (eg, due to a user removing power to devices on the CANbus) then it can result in the logs filling with error messages. Permanently disable the low-level processing of messages if CANbus writes continually fail for at least 10 seconds. This avoids filling the log with redundant messages. Signed-off-by: Kevin O'Connor <kevin@koconnor.net> |
||
|---|---|---|
| .github | ||
| config | ||
| docs | ||
| klippy | ||
| lib | ||
| scripts | ||
| src | ||
| test | ||
| .gitignore | ||
| COPYING | ||
| Makefile | ||
| README.md | ||
README.md
Welcome to the Klipper project!
Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.
To begin using Klipper start by installing it.
Klipper is Free Software. See the license or read the documentation. We depend on the generous support from our sponsors.