7a02cde4b7
This config I created and fully tested on my own printer Anycubic 4Max Pro 2.0. This works fine! Please note that this printer is different from the Anycubic 4MAX. Signed-off-by: Alexander Usachev <int_0x21@protonmail.com> |
||
|---|---|---|
| .. | ||
| sdcard_loop | ||
| bed_screws.cfg | ||
| bed_screws.test | ||
| bltouch.cfg | ||
| bltouch.test | ||
| commands.test | ||
| delta.test | ||
| delta_calibrate.cfg | ||
| delta_calibrate.test | ||
| dual_carriage.cfg | ||
| dual_carriage.test | ||
| extruders.cfg | ||
| extruders.test | ||
| gcode_arcs.cfg | ||
| gcode_arcs.test | ||
| macros.cfg | ||
| macros.test | ||
| manual_stepper.cfg | ||
| manual_stepper.test | ||
| move.gcode | ||
| multi_z.cfg | ||
| multi_z.test | ||
| out_of_bounds.test | ||
| polar.test | ||
| printers.test | ||
| pwm.cfg | ||
| pwm.test | ||
| quad_gantry_level.test | ||
| rotary_delta_calibrate.cfg | ||
| rotary_delta_calibrate.test | ||
| screws_tilt_adjust.cfg | ||
| screws_tilt_adjust.test | ||
| sdcard_loop.cfg | ||
| sdcard_loop.test | ||
| temperature.cfg | ||
| temperature.test | ||
| tmc.cfg | ||
| tmc.test | ||
| z_tilt.cfg | ||
| z_tilt.test | ||
| z_virtual_endstop.cfg | ||
| z_virtual_endstop.test | ||