5d52a3b19f
This commit contains a configuration for the Anycubic Vyper printer from 2021. It uses a clone of the STM32F103 chip named GD32F103. There are 2 Mainboard versions out there v0.0.5 and v0.0.6, this config has been tested with the v0.0.6 only. It should probably work for v0.0.5 as well since there are no different changes in the Anycubic Marlin firmware. The LCD is not supported yet (might work, but didn't try yet). Signed-off-by: Marc Neuhaus <marc@neuhaus.nrw> Signed-off-by: Manuel Fichtner <manuel.fichtner@me.com> |
||
|---|---|---|
| .. | ||
| sdcard_loop | ||
| bed_screws.cfg | ||
| bed_screws.test | ||
| bltouch.cfg | ||
| bltouch.test | ||
| commands.test | ||
| delta.test | ||
| delta_calibrate.cfg | ||
| delta_calibrate.test | ||
| dual_carriage.cfg | ||
| dual_carriage.test | ||
| extruders.cfg | ||
| extruders.test | ||
| gcode_arcs.cfg | ||
| gcode_arcs.test | ||
| macros.cfg | ||
| macros.test | ||
| manual_stepper.cfg | ||
| manual_stepper.test | ||
| move.gcode | ||
| multi_z.cfg | ||
| multi_z.test | ||
| out_of_bounds.test | ||
| polar.test | ||
| printers.test | ||
| pwm.cfg | ||
| pwm.test | ||
| quad_gantry_level.test | ||
| rotary_delta_calibrate.cfg | ||
| rotary_delta_calibrate.test | ||
| screws_tilt_adjust.cfg | ||
| screws_tilt_adjust.test | ||
| sdcard_loop.cfg | ||
| sdcard_loop.test | ||
| temperature.cfg | ||
| temperature.test | ||
| tmc.cfg | ||
| tmc.test | ||
| z_tilt.cfg | ||
| z_tilt.test | ||
| z_virtual_endstop.cfg | ||
| z_virtual_endstop.test | ||