Клиппер
Go to file
Kevin O'Connor 364c22fe84 probe: Rework the PROBE_ACCURACY command parameters
Don't default to a Z location of 10, as that could cause damage if the
probe's z_offset is greater than 10.  Instead, use the "retract
distance" method that is used for normal multi-sample probing.

Update the PROBE_ACCURACY command parameter names to use the same
parameter names as the PROBE command.

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
2019-07-10 15:21:09 -04:00
config config: Heater pins are inverted on the Duet2 Maestro 2019-07-10 13:23:59 -04:00
docs probe: Rework the PROBE_ACCURACY command parameters 2019-07-10 15:21:09 -04:00
klippy probe: Rework the PROBE_ACCURACY command parameters 2019-07-10 15:21:09 -04:00
lib lib: Add stm32f0 hal and cmsis files 2019-03-24 12:10:11 -04:00
scripts scripts: Minor improvement to feedback from travis-install.sh 2019-07-10 10:38:47 -04:00
src buttons: initialize mcu buttons based on inverted state 2019-07-05 20:01:07 -04:00
test tmc: Configure "intpol" field from TMCMicrostepHelper 2019-06-28 16:59:26 -04:00
.gitignore util: Fix versioning when gitdir is absent (#809) 2018-10-27 10:44:38 -04:00
.travis.yml test: Update .travis.yml to list apt packages one per line 2018-08-17 09:47:57 -04:00
COPYING Initial commit of source code. 2016-05-25 11:37:40 -04:00
Makefile makefile: Fixed build on OSX 2019-05-20 16:49:16 -04:00
README.md docs: Update main README file to point to website 2019-04-20 13:43:35 -04:00

README.md

Welcome to the Klipper project!

Klipper

https://www.klipper3d.org/

Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.

To begin using Klipper start by installing it.

Klipper is Free Software. See the license or read the documentation.