26e6ade175
If an USART RX overrun happened on a stm32g0/f0/h7, the ORE flag would get set by hardware. This flag would also trigger an interrupt. The problem was that this flag was never cleared on these 3 mcu families since the ORE flag clear sequence is different to all of the older chips. Since the ORE flag is not used in any meaningful way anyway, it was disabled during the init sequence. Signed-off-by: Alex Voinea <voinea.dragos.alexandru@gmail.com> |
||
|---|---|---|
| .github | ||
| config | ||
| docs | ||
| klippy | ||
| lib | ||
| scripts | ||
| src | ||
| test | ||
| .gitignore | ||
| COPYING | ||
| Makefile | ||
| README.md | ||
README.md
Welcome to the Klipper project!
Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.
To begin using Klipper start by installing it.
Klipper is Free Software. See the license or read the documentation. We depend on the generous support from our sponsors.