klipper

Клиппер

Go to file

Kevin O'Connor 1b989b81e0 tmc: Fix order of init during sensorless homing With commit `53b10d3a` the setup of sensorless homing could occur before the driver was enabled which would cause the reinitialization of the driver settings to undo the sensorless homing setup. Use set_field() when setting the sensorless homing registers so that it wont conflict with a driver init. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>		2021-02-28 18:30:25 -05:00
.github/workflows	workflows: Update stale-issue-bot.yaml to also close invalid tickets	2021-02-02 13:22:35 -05:00
config	config: fan pin number correction for Robin Nano 3 (#4005 )	2021-02-28 16:17:21 -05:00
docs	tmc: Add support for periodic checking of driver status	2021-02-27 10:39:47 -05:00
klippy	tmc: Fix order of init during sensorless homing	2021-02-28 18:30:25 -05:00
lib	lib: add FatFS notes to README	2021-02-05 19:37:56 -05:00
scripts	logextract: Improve handling of TMC UART read/write register commands	2021-02-28 17:15:29 -05:00
src	stm32: Add support for 48KiB bootloaders	2021-02-20 09:37:43 -05:00
test	test: Add printer-flsun-q5-2020.cfg to printers.test and minor changes	2021-02-22 15:29:34 -05:00
.gitignore	util: Fix versioning when gitdir is absent (#809 )	2018-10-27 10:44:38 -04:00
COPYING	Initial commit of source code.	2016-05-25 11:37:40 -04:00
Makefile	Makefile: Improve build when changing micro-controller architecture	2020-12-17 10:02:16 -05:00
README.md	docs: Update main README file to point to website	2019-04-20 13:43:35 -04:00

README.md

Welcome to the Klipper project!

https://www.klipper3d.org/

Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.

To begin using Klipper start by installing it.

Klipper is Free Software. See the license or read the documentation.