3diy
/
klipper
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity
klipper/docs/CANBUS.md

2.6 KiB
Raw Blame History

This document describes Klipper's CAN bus support.

Device Hardware

Klipper currently only supports CAN on stm32 chips. In addition, the micro-controller chip must support CAN and it must be on a board that has a CAN transceiver.

To compile for CAN, run "make menuconfig", unselect "Use USB for communication (instead of serial)" and then select "Use CAN for communication (instead of serial)". Finally, compile the micro-controller code and flash it to the target board.

Host Hardware

In order to use a CAN bus, it is necessary to have a host adapter. There are currently two common options:

  1. Use a Waveshare Raspberry Pi CAN hat or one of its many clones.

  2. Use a USB CAN adapter (for example https://hacker-gadgets.com/product/cantact-usb-can-adapter/). There are many different USB to CAN adapters available - when choosing one, we recommend verifying it can run the candlelight firmware. (Unfortunately, we've found some USB adapters run defective firmware and are locked down, so verify before purchasing.)

It is also necessary to configure the host operating system to use the adapter. This is typically done by creating a new file named /etc/network/interfaces.d/can0 with the following contents:

auto can0
iface can0 can static
    bitrate 500000
    up ifconfig $IFACE txqueuelen 128

Note that the "Raspberry Pi CAN hat" also requires changes to config.txt.

Finding the canbus_uuid for new micro-controllers

Each micro-controller on the CAN bus is assigned a unique id based on the factory chip identifier encoded into each micro-controller. To find each micro-controller device id, make sure the hardware is powered and wired correctly, and then run:

~/klippy-env/bin/python ~/klipper/scripts/canbus_query.py can0

If uninitialized CAN devices are detected the above command will report lines like the following:

Found canbus_uuid=11aa22bb33cc

Each device will have a unique identifier. In the above example, 11aa22bb33cc is the micro-controller's "canbus_uuid".

Note that the canbus_query.py tool will only report uninitialized devices - if Klipper (or a similar tool) configures the device then it will no longer appear in the list.

Configuring Klipper

Update the Klipper mcu configuration to use the CAN bus to communicate with the device - for example:

[mcu my_can_mcu]
canbus_uuid: 11aa22bb33cc