# Test config for sdcard_loop
[virtual_sdcard]
path: test/klippy/sdcard_loop

[display_status]

# Override to support unlimited belt size
# (homing Z simply resets its virtual position to 0.0)
[homing_override]
axes: xyz
set_position_x: 0
set_position_y: 0
set_position_z: 0
gcode:
  G92 X0 Y0 Z0


[stepper_x]
step_pin: PF0
dir_pin: PF1
enable_pin: !PD7
microsteps: 16
rotation_distance: 40
endstop_pin: ^PE5
position_endstop: 0
position_max: 200
homing_speed: 50

[stepper_y]
step_pin: PF6
dir_pin: !PF7
enable_pin: !PF2
microsteps: 16
rotation_distance: 40
endstop_pin: ^PJ1
position_endstop: 0
position_max: 200
homing_speed: 50

[stepper_z]
step_pin: PL3
dir_pin: PL1
enable_pin: !PK0
microsteps: 16
rotation_distance: 8
endstop_pin: ^PD3
position_endstop: 0.5
position_max: 200000000

[extruder]
step_pin: PA4
dir_pin: PA6
enable_pin: !PA2
microsteps: 16
rotation_distance: 33.5
nozzle_diameter: 0.500
filament_diameter: 3.500
heater_pin: PB4
sensor_type: EPCOS 100K B57560G104F
sensor_pin: PK5
control: pid
pid_Kp: 22.2
pid_Ki: 1.08
pid_Kd: 114
min_temp: 0
max_temp: 210

[heater_bed]
heater_pin: PH5
sensor_type: EPCOS 100K B57560G104F
sensor_pin: PK6
control: watermark
min_temp: 0
max_temp: 110

[mcu]
serial: /dev/ttyACM0

[printer]
kinematics: cartesian
max_velocity: 300
max_accel: 3000
max_z_velocity: 5
max_z_accel: 100

[sdcard_loop]

[gcode_macro M808]
gcode:
    {% if params.K is not defined and params.L is defined %}SDCARD_LOOP_BEGIN COUNT={params.L|int}{% endif %}
    {% if params.K is not defined and params.L is not defined %}SDCARD_LOOP_END{% endif %}
    {% if params.K is defined and params.L is not defined %}SDCARD_LOOP_DESIST{% endif %}