# Main Kconfig settings

mainmenu "Klipper Firmware Configuration"

choice
    prompt "Micro-controller Architecture"
    config MACH_AVR
        bool "Atmega AVR"
    config MACH_SIMU
        bool "Host simulator"
endchoice

source "src/avr/Kconfig"
source "src/simulator/Kconfig"

# The HAVE_GPIO_x options allow boards to disable support for some
# commands if the hardware does not support the feature.
config HAVE_GPIO_ADC
    bool
    default n
config HAVE_GPIO_SPI
    bool
    default n
config HAVE_GPIO_HARD_PWM
    bool
    default n

config NO_UNSTEP_DELAY
    # Slow micro-controllers do not require a delay before returning a
    # stepper step pin to its default level.  A board can enable this
    # option to optimize the stepper_event() handler in this case.
    bool
    default n

config INLINE_STEPPER_HACK
    # Enables gcc to inline stepper_event() into the main timer irq handler
    bool
    default y if MACH_AVR
    default n