Config file contains pin mappings to suit Lulzbot Mini 2 using Lulzbot SingleExtruder(0.5mm) and Lulzbot flexible magnetic bed.
Mini 2 uses Einsy Retro mainboard.
Signed-off-by: Trent Sheather <trent.sheather@gmail.com>
Minor fix. The screw labels "back left" and "back right"
where swapped in [screws_tilt_adjust] section.
Signed-off-by: Frank Roth <developer@freakydu.de>
Works for unmodified stock Artillery Sidewinder X2,
year 2022 with Artillery Ruby v1.2 mainboard.
All by default connected things are working fine.
Build firmware with architecture STM32F401 with "No bootloader".
Other settings keep ther defaults
Signed-off-by: Frank Roth <developer@freakydu.de>
Corrected the build instructions for the TH3D EZBoard V2 to include the command to convert Klipper.elf to a SREC bin format named firmware.bin. The SREC format is required for the bootloader installed on the board.
Signed-off-by: Anthony Dellett <anthony.dellett@gmail.com>
* Update printer-anycubic-vyper-2021.cfg
better pause and end print, beeper support, mroe accurate value.
* Update printer-anycubic-vyper-2021.cfg
* Update printer-anycubic-vyper-2021.cfg
* Update printer-anycubic-vyper-2021.cfg
* Update printer-anycubic-vyper-2021.cfg
delete unnecessary gcode
* Update printer-anycubic-vyper-2021.cfg
remove unneccessary part.
* Update printer-anycubic-vyper-2021.cfg
* Update printer-anycubic-vyper-2021.cfg
according to https://www.klipper3d.org/Example_Configs.html point 7f
delete field values that are set to their default value
* Update printer-anycubic-vyper-2021.cfg
small change
* Update printer-anycubic-vyper-2021.cfg
As found on discord bt user David Carey.
uart_address for y and z are swapped. Discovered while setting up sensorless homing.
Signed off by: James Hartley <james@hartleyns.com>
Added a SET_DIGIPOT command to the mcp4018 implementation.
Previously the mcp4018 was read only, and set at the time of
configuration. This allows you to change the value during a
print, which is needed for some older printers that need to
lower the stepper current during preheating.
Signed-off-by: Jake Bordens <jake@allaboutjake.com>
This is a working config with full LCD and stepper settings (only thing missing is the kill switch, which did not appear to work)
Signed-off-by: Rui Carmo <rui.carmo@gmail.com>
This is a working config with full LCD and stepper settings (only thing missing is the kill switch, which did not appear to work)
Signed-off-by: Rui Carmo <rui.carmo@gmail.com>
This PR serves to fix a longstanding misnomer in some config files. Many configs state a nozzle_cooling_fan alias for what is usually a "hotend cooling fan". This causes ambiguity and confusion with the parts fan. I have identified all 24 files with this and changed them here.
Signed-off-by: James Hartley <james@hartleyns.com>
Introduce support for the stock Creality CR10 v3 printer, including the filament runout sensor. It also supports the optional BLTouch.
Signed-off-by: Luís Palma Nunes Mendes <luis.p.mendes@gmail.com>
spinixguy