Support the rp2040 (as tested on a Raspberry Pi Pico board). This
adds basic uart, timer, gpio, and watchdog support.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Adds Duet3 Mini Config with support for expansion header
Signed-off-by: Luke Ashley <Luke@Lukeslab.online>
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
* Add F429 variant; add CAN on PD0,PD1; add 25Mhx clock; move CAN1_RX from PI8 to correct position (PI9)
* Add test for STM32F429
Signed-off-by: Arkadiusz Raj <arek.raj@gmail.com>
Now that the code in stm32f4/ can handle both stm32f1 and stm32f4
chips, rename the directory to just "stm32".
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Most of the peripherals on the sam4e8e are similar to the ones on the
sam3x8e mcu. Merge the code together and use just one code directory.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This can be flashed to e.g. the duet wifi using bossac. It requires a
later version as is currently included in the klipper repo (1.8
vs. 1.2). Comms are currently via UART0 only, USB serial is still TBD
Signed-off-by: Florian Heilmann <Florian.Heilmann@gmx.net>
Move the travis installation steps from the travis-build.sh script to
a new script (scripts/travis-install.sh). Move the travis-build.sh
script to the scripts/ directory as well.
The data dictionaries built in the compile tests are useful during
host software testing, so run all the compile tests sequentially in a
single VM and save the data dictionaries after each build. Also,
build all the config files found in the test/configs/ directory.
Create the python virtualenv environment during the install phase and
invoke the klippy.py host software in the build phase to perform a
basic host software sanity check.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Kevin O'Connor