klipper

Author	SHA1	Message	Date
Kevin O'Connor	9dfe612516	verify_heater: Provide additional information on a heater error Signed-off-by: Kevin O'Connor <kevin@koconnor.net>	2018-03-12 23:31:17 -04:00
Kevin O'Connor	849f4ed25f	verify_heater: Scale hysteresis duration check If a heater falls out of the target range, accumulate the temperature differences to determine if an error should be raised. This should make it less likely to report an error for heaters that drift slightly out of range, and it should make error reporting faster for heaters that rapidly fall out of range. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>	2018-03-11 19:21:32 -04:00
Kevin O'Connor	57d342b455	verify_heater: Change default hysteresis to 10 degrees A default of 4 degrees and 10 seconds may be too aggressive - change the default to 10 degrees and 15 seconds. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>	2018-03-11 13:29:28 -04:00
Kevin O'Connor	5208fc38ed	verify_heater: Add initial support for verifying heaters and sensors Add runtime checks to heaters and temperature sensors to check for possible hardware faults. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>	2018-03-11 00:49:11 -05:00