Commit Graph

7 Commits

Author SHA1 Message Date
Steven Snyder 64097cb0d0
config: Updates to TAZ6 single extruder config (#3750)
The Lulzbot TAZ6 single extruder configuration had an XY position for
z homing that did not match the factory firmware, and was off center
enough to cause the extruder to crash into the home button trim
sometimes when homing. This commit changes the printer config so
that the XY position for Z homing matches the original Marlin firmware
for this printer.

The Lulzbot TAZ6 single extruder configuration had an bed_tilt points
that did not match the factory firmware, and were off enough that the
nozzle (used for probing on this printer) could slip off the edge of
the probe point or miss it entirely. This commit changes the printer
config so that the coordinates for bed_tilt calibration match the
original Marlin firmware for this printer.

For the Lulzbot TAZ6 single extruder config, use 'gear_ratio' and
'rotation_distance' to configure the extruder.

The rotation distance is based on effective circumference of the hobbed
bolt based on the original Marlin firmware for the TAZ6 single-extruder,
and the gear ratio was determined by simply counting the number of
teeth on the pinion and spur gears.

Signed-off-by: Steven T. Snyder <github@steventsnyder.com>
2021-01-14 11:01:58 -05:00
Kevin O'Connor 49f1ee0207 config: Update example configs to use rotation_distance
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
2020-12-18 10:38:49 -05:00
Kevin O'Connor 15b5dbaf8f docs: Move config reference information to new Config_Reference.md
Move all the config reference information from files in the config/
directory to a new Config_Reference.md document.

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
2020-11-18 20:10:21 -05:00
Kevin O'Connor 17f2b4e960 config: Fix minor typo in printer-lulzbot-taz6-2017.cfg
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
2020-02-18 12:11:19 -05:00
Chris Lee 90500c331a config: Update TAZ6 configuration
Support probing the corner washers for the bed tilt using G29,
flesh out the rest of the configuration for the display, and add
support for the Aerostruder (commented out by default).

Signed-Off-By: Chris Lee <clee@mg8.org>
2020-02-18 12:10:09 -05:00
Kevin O'Connor 08a5f8a5ff display: Add initial support for LCD screens attached to an MCU
Add support for displaying basic status information on ST7920 and
HD44780 based LCDs that are attached directly to a micro-controller.

Signed-off-by: Marcio Teixeira <marcio@alephobjects.com>
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
2018-03-06 11:30:46 -05:00
Kevin O'Connor 41f73d0c8c config: Add a "printer-" prefix to example printer config files
Add a prefix to the example printer config files so that a sorted
directory listing shows all the samples bundled together.

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
2018-02-11 14:58:48 -05:00