The control bytes for the AHT20 and AHT21 are identical to the AHT10, but I had not been able to test just yet to ensure the sensor code supported the other sensors. I've wrapped up testing and updated the comments/docs to reflect this additional support.
Signed-off-by: Scott Mudge <mail@scottmudge.com>
Correction for table "Recommended connection scheme for I2C (i2c0a) on the RP2040", line 160, to match the correct writing in the Fritzing image shown above, RP2040 pin 36 in place of 39;
Correction of typo in line 346, "pins" in place of "pin"
Signed-off-by: Adrian Rose <adrian@crazyroses.net>
In some condition ，“drvstrength 2” does not work. According to page 17, some mosfets need “drvstrength” set to 0 .
From datasheet rev1.15, the DRVSTRENGTH reset default is 0 . (instead of 2)
Signed-off-by: Albert Lin <vcore85@gmail.com>
The stalled_bytes counter refers to the number of bytes that are not
yet eligible for transmission. However, the naming leads to confusion
as it could be interpretted as an inability to transmit data. Rename
to upcoming_bytes to try to avoid that confusion.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Add an optional REGISTER parameter to DUMP_TMC so that the output is more filtered/cleaner for manual TMC calibration.
Signed-off-by: Alex Voinea <voinea.dragos.alexandru@gmail.com>
Ability to specify `VELOCITY` as a parameter for SET_TMC_FIELD. Useful for configuring at runtime the TSTEP based fields of the driver.
Signed-off-by: Alex Voinea <voinea.dragos.alexandru@gmail.com>
Previously, the globalscaler was calculated during the config parsing and set to a fixed value. If the current was changed for any reason after the initialization, only IRUN and IHOLD would be changed. This however caused issues:
- If the new current was lower, then the resolution of the possible current values would be low since there are only 32 IRUN/IHOLD steps.
- If the new current was higher, it wouldn't actually work since IRUN and IHOLD are capped at 31, so it wouldn't be possible to increase the current without increasing globalscaler.
With this commit, the globalscaler is recalculated whenever necessary in order to ensure the correct range of IRUN/IHOLD is used.
Signed-off-by: Alex Voinea <voinea.dragos.alexandru@gmail.com>
Later addition of a F429 variant SKR2 was released. Changed btt-skr2 to btt-skr-2-f407 and added a new alias for btt-skr-2-f429
Signed-off-by: James Hartley <james@hartleyns.com>
Make all the microstep lookup table registers configurable via the
config file. It also loads the default values.
TMC220x and TMC2660 do not support this feature.
Signed-off-by: Alex Voinea <voinea.dragos.alexandru@gmail.com>
add G17, G18 and G19 commands to select arc planes
enhance G2/G3 to support arc moves in XY, XZ and YZ planes
Signed-off-by: Andrew Mirsky <andrew@mirsky.net>
After a G28 z-axis homing, there is a final z hop.
It was hoping to height z_hop as an absolute z height rather than relative.
If the z-axis home leaves the head at a z height higher than z_hop,
e.g. because you were using a probe to do z homing,
this meant that it was z hopping in the negative z direction, which
could result in crashing the toolhead.
Signed-off-by: Joshua Redstone <redstone@gmail.com>
Chris