Add PROBE and CHIP to TEST_RESONANCES
Since it's possible to specify more than one chip
in TEST_RESONANCES the CHIP parameter has been
renamed to CHIPS
Signed-off-by: Mikkel Schmidt <mikkel.schmidt@gmail.com>
Make sure whitespace isn't in the pin description. Also make sure an
alias doesn't map to an invalid pin.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Minor indentation and variable name changes.
Don't remove linebreaks from message_protocol_error lines.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
The MCU protocol error message often confuses users, especially after getting bombarded with the config format error line. This PR tries to improve it and has the following goals:
- Put the technical error at the end to prevent confusion and avoid the immediate jump to help channels instead of continuing to read
- Inform the user first what the type of error is (In this case: MCU Protocol error) and not at the end of the long error message
- Give the users a clear instruction what to do (pretty much unchanged), but possibly more approachable because the user is not confused by the technical error anymore
- Shows the version numbers of Klipper separate from all MCU version numbers so that it is more obvious that this is the version of Klipper
- Separates the version numbers between outdated MCUs and up-to-date MCUs, so that it becomes obvious if a MCU flash failed because the MCU doesn't disappear from the outdated list
- Previously, when viewing the errors in a web frontend, additional line breaks made it extremely hard to read the message, sometimes with as little as one word on one line. The error messages are now formatted to not have rogue line breaks, improving readability.
Signed-off-by: Felicia Alexa Hummel <felicia@drachenkatze.org>
If the final update in a series of SET_LED update commands didn't
alter a color than the transmit would not occur - even if prior
commands did make color changes. Refactor the update code and fix.
Reported by @mstansberry.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This is most probably the result of a copy paste error. All vendor documentation for SI7021 (e.g. https://www.silabs.com/documents/public/data-sheets/Si7021-A20.pdf) points to 21 and it actually only works when adapted to 0x15 (=21).
Signed-off-by: Uli Wolf <github+klipper@wolf-u.li>
Added PCA9632 LED module support using software I2C from MCP4018
modulo drive the LED strip of a FlashForge Dreamer 3D printer.
Based on the PCA9533 module.
Signed-off-by: Ricardo Alcantara <ricardo@vulcanolabs.xyz>
Check that a SET_PRESSURE_ADVANCE without an explicit EXTRUDER
parameter isn't done after the user disables or reassociates the
extruder stepper motor (via SYNC_EXTRUDER_MOTION). Otherwise, it
could lead to very confusing results.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
With recent changes, the extruder_stepper may be used for new
purposes, and synchronizing to the "extruder" motion queue at startup
may become a confusing default.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Troy Jacobson