From f7c2d918b657bc6572002f817cfbb49e9d5dcc8d Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Sun, 8 Jul 2018 10:45:17 -0400 Subject: [PATCH] config: Update Smoothieboard configs with notes on flashing the devices Signed-off-by: Kevin O'Connor --- config/generic-re-arm.cfg | 5 +++++ config/generic-smoothieboard.cfg | 11 +++++++---- 2 files changed, 12 insertions(+), 4 deletions(-) diff --git a/config/generic-re-arm.cfg b/config/generic-re-arm.cfg index ab388a4c..1653fce3 100644 --- a/config/generic-re-arm.cfg +++ b/config/generic-re-arm.cfg @@ -1,6 +1,11 @@ # This file contains common pin mappings for Re-Arm. To use this # config, the firmware should be compiled for the LPC176x. +# The "make flash" command does not work on the Re-Arm. Instead, +# after running "make", copy the generated "out/klipper.bin" file to a +# file named "firmware.bin" on an SD card and then restart the Re-Arm +# with that SD card. + # See the example.cfg file for a description of available parameters. [stepper_x] diff --git a/config/generic-smoothieboard.cfg b/config/generic-smoothieboard.cfg index d52fff07..48226cbb 100644 --- a/config/generic-smoothieboard.cfg +++ b/config/generic-smoothieboard.cfg @@ -1,7 +1,10 @@ -# This file contains common pin mappings for Smoothieboard. To use this -# config, the firmware should be compiled for the LPC176x. +# This file contains common pin mappings for Smoothieboard. To use +# this config, the firmware should be compiled for the LPC176x. -# THIS FILE HAS NOT BEEN TESTED - PROCEED WITH CAUTION! +# The "make flash" command does not work on the Smoothieboard. +# Instead, after running "make", copy the generated "out/klipper.bin" +# file to a file named "firmware.bin" on an SD card and then restart +# the Smoothieboard with that SD card. # See the example.cfg file for a description of available parameters. @@ -88,7 +91,7 @@ pins: P1.18, P1.19, P1.20, P1.21, P4.28 [mcp4451 stepper_digipot1] i2c_address: 88 -# Scale the config so that values can be specified in amps. +# Scale the config so that wiper values can be specified in amps. scale: 2.25 # wiper 0 is X (aka alpha), 1 is Y, 2 is Z, 3 is E0 wiper_0: 1.0