config: update examples-extra.cfg to include the bed_mesh module

Signed-off-by: Eric Callahan <arksine.code@gmail.com>
This commit is contained in:
Arksine 2018-08-10 17:08:06 -04:00 committed by KevinOConnor
parent e0bd221c57
commit f337fb1802
1 changed files with 60 additions and 0 deletions

View File

@ -65,6 +65,66 @@
# and true otherwise.
# Mesh Bed Leveling. One may define a [bed_mesh] config section
# to enable move transformations that offset the z axis based
# on a mesh generated from probed points. Note that bed_mesh
# and bed_tilt are incompatible, both cannot be defined.
#[bed_mesh]
#speed: 50
# The speed (in mm/s) of non-probing moves during the
# calibration. The default is 50.
#horizontal_move_z: 5
# The height (in mm) that the head should be commanded to move to
# just prior to starting a probe operation. The default is 5.
#probe_offset:
# An X,Y point defining the probe's offset relative to the nozzle.
# This parameter must be provided.
#min_point:
# An X,Y point defining the minimum coordinate to probe on
# the bed. Note that this refers to the nozzle position,
# and take care that you do not define a point that will move
# the probe off of the bed. This parameter must be provided.
#max_point:
# An X,Y point defining the maximum coordinate to probe on
# the bed. Follow the same precautions as listed in min_point.
# Also note that this does not necessarily define the last point
# probed, only the maximum coordinate. This parameter must be provided.
#probe_count: 3,3
# A comma separated pair of integer values (X,Y) defining the number
# of points to probe along each axis. A single value is also valid,
# in which case that value will be for both axes. Default is 3,3
# which probes a 3x3 grid.
#fade_start: 1.0
# The z-axis position in which to start phasing z-adjustment out.
# Default is 1.0.
#fade_end: 10.0
# The z-axis position in which phase out is complete. If this
# value is less than or equal to fade_start then phasing out
# is disabled. Default is 10.0.
#split_delta_z: .025
# The amount of Z difference (in mm) along a move that will
# trigger a split. Default is .025.
#move_check_distance: 5.0
# The distance (in mm) along a move to check for split_delta_z.
# This is also the minimum length that a move can be split. Default
# is 5.0.
#mesh_pps: 2,2
# A comma separated pair of integers (X,Y) defining the number of
# points per segment to interpolate in the mesh along each axis. A
# "segment" can be defined as the space between each probed
# point. The user may enter a single value which will be applied
# to both axes. Default is 2,2.
#algorithm: lagrange
# The interpolation algorthm to use. May be either "langrange"
# or "bicubic". This option will not affect 3x3 grids, which
# are forced to use lagrange sampling. Default is lagrange.
#bicubic_tension: .2
# When using the bicubic algoritm the tension parameter above
# may be applied to change the amount of slope interpolated.
# Larger numbers will increase the amount of slope, which
# results in more curvature in the mesh. Default is .2.
# Multiple Z stepper tilt adjustment. This feature enables independent
# adjustment of multiple z steppers (see stepper_z1 section below) to
# adjust for tilt. If this section is present then a Z_TILT_ADJUST