3diy
/
klipper
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity

docs: Move palette2 location in Config_Reference.md 

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This commit is contained in:
Kevin O'Connor 2021-04-28 20:40:24 -04:00
parent ebbb21be00
commit e77bf7431e
1 changed files with 36 additions and 36 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

72
docs/Config_Reference.md
View File

@ -3837,6 +3837,42 @@ host_mcu:
# (True sets CFG5 high, False sets it low). The default is True.
```
# Other Custom Modules
## [palette2]
Palette 2 multimaterial support - provides a tighter integration
supporting Palette 2 devices in connected mode.
This modules also requires `[virtual_sdcard]` and `[pause_resume]`
for full functionality.
If you use this module, do not use the Palette 2 plugin for
Octoprint as they will conflict, and 1 will fail to initialize
properly likely aborting your print.
If you use Octoprint and stream gcode over the serial port instead of
printing from virtual_sd, then remo **M1** and **M0** from *Pausing commands*
in *Settings > Serial Connection > Firmware & protocol* will prevent
the need to start print on the Palette 2 and unpausing in Octoprint
for your print to begin.
```
[palette2]
serial:
# The serial port to connect to the Palette 2.
#baud: 115200
# The baud rate to use. The default is 115200.
#feedrate_splice: 0.8
# The feedrate to use when splicing, default is 0.8
#feedrate_normal: 1.0
# The feedrate to use after splicing, default is 1.0
#auto_load_speed: 2
# Extrude feedrate when autoloading, default is 2 (mm/s)
#auto_cancel_variation: 0.1
# Auto cancel print when ping varation is above this threshold
```
# Common bus parameters
## Common SPI settings
@ -3882,39 +3918,3 @@ I2C bus.
# On some micro-controllers changing this value has no effect. The
# default is 100000.
```
# Other Custom Modules
## [palette2]
Palette 2 multimaterial support - provides a tighter integration
supporting Palette 2 devices in connected mode.
This modules also requires `[virtual_sdcard]` and `[pause_resume]`
for full functionality.
If you use this module, do not use the Palette 2 plugin for
Octoprint as they will conflict, and 1 will fail to initialize
properly likely aborting your print.
If you use Octoprint and stream gcode over the serial port instead of
printing from virtual_sd, then remo **M1** and **M0** from *Pausing commands*
in *Settings > Serial Connection > Firmware & protocol* will prevent
the need to start print on the Palette 2 and unpausing in Octoprint
for your print to begin.
```
[palette2]
serial:
# The serial port to connect to the Palette 2.
#baud: 115200
# The baud rate to use. The default is 115200.
#feedrate_splice: 0.8
# The feedrate to use when splicing, default is 0.8
#feedrate_normal: 1.0
# The feedrate to use after splicing, default is 1.0
#auto_load_speed: 2
# Extrude feedrate when autoloading, default is 2 (mm/s)
#auto_cancel_variation: 0.1
# Auto cancel print when ping varation is above this threshold
```