diff --git a/config/example.cfg b/config/example.cfg
index 2119b3c9..96bddafb 100644
--- a/config/example.cfg
+++ b/config/example.cfg
@@ -256,13 +256,13 @@ pin_map: arduino
 #restart_method: arduino
 #   This controls the mechanism the host will use to reset the
 #   micro-controller. The choices are 'arduino', 'rpi_usb', and
-#   'command'. The 'arduino' method (toggle DTR; set baud to 1200) is
-#   common on Arduino boards and clones. The 'rpi_usb' method is
-#   useful on Raspberry Pi boards with micro-controllers powered over
-#   USB - it briefly disables power to all USB ports to accomplish a
-#   micro-controller reset. The 'command' method involves sending a
-#   Klipper command to the micro-controller so that it can reset
-#   itself. The default is 'arduino'.
+#   'command'. The 'arduino' method (toggle DTR) is common on Arduino
+#   boards and clones. The 'rpi_usb' method is useful on Raspberry Pi
+#   boards with micro-controllers powered over USB - it briefly
+#   disables power to all USB ports to accomplish a micro-controller
+#   reset. The 'command' method involves sending a Klipper command to
+#   the micro-controller so that it can reset itself. The default is
+#   'arduino'.
 
 # The printer section controls high level printer settings.
 [printer]
diff --git a/klippy/serialhdl.py b/klippy/serialhdl.py
index 8d6d6a7f..e7e35bf8 100644
--- a/klippy/serialhdl.py
+++ b/klippy/serialhdl.py
@@ -272,11 +272,11 @@ def stk500v2_leave(ser, reactor):
 
 # Attempt an arduino style reset on a serial port
 def arduino_reset(serialport, reactor):
-    # First try opening the port at 1200 baud
-    ser = serial.Serial(serialport, 1200, timeout=0)
+    # First try opening the port at a different baud
+    ser = serial.Serial(serialport, 2400, timeout=0)
     ser.read(1)
     reactor.pause(reactor.monotonic() + 0.100)
-    # Then try toggling DTR
+    # Then toggle DTR
     ser.dtr = True
     reactor.pause(reactor.monotonic() + 0.100)
     ser.dtr = False