3diy
/
klipper
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity

config: Minor changes to printer-creality-cr30-2021.cfg 

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This commit is contained in:
Kevin O'Connor 2021-05-06 11:08:57 -04:00
parent 44387568f3
commit dfcdd51e7f
2 changed files with 1 additions and 3 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

3
config/generic-creality-v4.2.10.cfg
View File

@ -2,13 +2,13 @@
# use this config, during "make menuconfig" select the STM32F103 with
# a "28KiB bootloader" and serial (on USART1 PA10/PA9) communication.
# Flash this firmware by copying "out/klipper.bin" to a SD card and
# If you prefer a direct serial connection, in "make menuconfig"
# select "Enable extra low-level configuration options" and select
# serial (on USART3 PB11/PB10), which is broken out on the 10 pin IDC
# cable used for the LCD module as follows:
# 3: Tx, 4: Rx, 9: GND, 10: VCC
# Flash this firmware by copying "out/klipper.bin" to a SD card and
# turning on the printer with the card inserted. The firmware
# filename must end in ".bin" and must not match the last filename
# that was flashed.
@ -81,7 +81,6 @@ max_temp: 130
[mcu]
serial: /dev/serial/by-id/usb-1a86_USB_Serial-if00-port0
baud: 250000
restart_method: command
[printer]

1
config/printer-creality-cr30-2021.cfg
View File

@ -125,7 +125,6 @@ static_value: 0
[mcu]
serial: /dev/serial/by-id/usb-1a86_USB_Serial-if00-port0
baud: 250000
restart_method: command
[display]