docs: Pressure_Advance.md should recommend setting ADVANCE_LOOKAHEAD_TIME
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This commit is contained in:
parent
c794e11c67
commit
ccbdb6c531
|
@ -22,11 +22,12 @@ Use a slicer to generate g-code for the large hollow square found in
|
|||
speed (eg, 100mm/s), zero infill, and a coarse layer height (the layer
|
||||
height should be around 75% of the nozzle diameter).
|
||||
|
||||
Prepare for the test by issuing the following G-Code command:
|
||||
Prepare for the test by issuing the following G-Code commands:
|
||||
```
|
||||
SET_VELOCITY_LIMIT SQUARE_CORNER_VELOCITY=1 ACCEL=500
|
||||
SET_PRESSURE_ADVANCE ADVANCE_LOOKAHEAD_TIME=0
|
||||
```
|
||||
This command makes the nozzle travel slower through corners and to
|
||||
These commands make the nozzle travel slower through corners and they
|
||||
emphasize the effects of extruder pressure. Then for printers with a
|
||||
direct drive extruder run the command:
|
||||
```
|
||||
|
|
Loading…
Reference in New Issue