diff --git a/config/printer-creality-cr20-pro-2019.cfg b/config/printer-creality-cr20-pro-2019.cfg
index 6fc86d4f..0aed3f88 100644
--- a/config/printer-creality-cr20-pro-2019.cfg
+++ b/config/printer-creality-cr20-pro-2019.cfg
@@ -12,8 +12,6 @@ endstop_pin: ^PE5
 position_endstop: 0
 position_max: 235
 homing_speed: 100
-second_homing_speed: 50
-homing_retract_dist: 5
 
 [stepper_y]
 step_pin: PF6
@@ -24,8 +22,6 @@ endstop_pin: ^PJ1
 position_endstop: 0
 position_max: 235
 homing_speed: 100
-second_homing_speed: 50
-homing_retract_dist: 5
 
 [stepper_z]
 step_pin: PL3
@@ -45,7 +41,6 @@ enable_pin: !PA2
 step_distance: .010526
 nozzle_diameter: 0.400
 filament_diameter: 1.750
-pressure_advance: 0.9 # please calibrate!
 heater_pin: PB4
 sensor_type: EPCOS 100K B57560G104F
 sensor_pin: PK5
@@ -62,7 +57,6 @@ control_pin: PB5
 z_offset: 3.60
 x_offset: 46
 y_offset: 9
-pin_move_time: 0.15
 speed: 3.0
 samples: 1
 
@@ -78,8 +72,6 @@ horizontal_move_z: 8
 min_point: 60,30
 max_point: 235,220
 probe_count: 3,3
-fade_start: 1.0
-fade_end: 0 # disable fading
 
 [heater_bed]
 heater_pin: PH5
diff --git a/test/klippy/printers.test b/test/klippy/printers.test
index 57c91ec3..78a8dd47 100644
--- a/test/klippy/printers.test
+++ b/test/klippy/printers.test
@@ -25,6 +25,7 @@ CONFIG ../../config/printer-anycubic-kossel-2016.cfg
 CONFIG ../../config/printer-anycubic-kossel-plus-2017.cfg
 CONFIG ../../config/printer-creality-cr10s-2017.cfg
 CONFIG ../../config/printer-creality-cr20-2018.cfg
+CONFIG ../../config/printer-creality-cr20-pro-2019.cfg
 CONFIG ../../config/printer-lulzbot-taz6-2017.cfg
 CONFIG ../../config/printer-lulzbot-taz6-dual-v3-2017.cfg
 CONFIG ../../config/printer-makergear-m2-2012.cfg