From a77d07907fdfcd76f7175231caee170db205ff04 Mon Sep 17 00:00:00 2001 From: Pedro Lamas Date: Fri, 16 Feb 2024 12:42:25 +0000 Subject: [PATCH] docs: updates BED_MESH_CALIBRATE description Adds the ADAPTIVE and ADAPTIVE_MARGIN parameters to the documentation. Signed-off-by: Pedro Lamas --- docs/G-Codes.md | 16 +++++++++++----- 1 file changed, 11 insertions(+), 5 deletions(-) diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 5a8cd920..199dc283 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -146,15 +146,21 @@ The following commands are available when the (also see the [bed mesh guide](Bed_Mesh.md)). #### BED_MESH_CALIBRATE -`BED_MESH_CALIBRATE [METHOD=manual] [HORIZONTAL_MOVE_Z=] -[=] [=]`: This command probes -the bed using generated points specified by the parameters in the config. After -probing, a mesh is generated and z-movement is adjusted according to the mesh. +`BED_MESH_CALIBRATE [PROFILE=] [METHOD=manual] [HORIZONTAL_MOVE_Z=] +[=] [=] [ADAPTIVE=1] +[ADAPTIVE_MARGIN=]`: This command probes the bed using generated points +specified by the parameters in the config. After probing, a mesh is generated +and z-movement is adjusted according to the mesh. +The mesh will be saved into a profile specified by the `PROFILE` parameter, +or `default` if unspecified. See the PROBE command for details on the optional probe parameters. If METHOD=manual is specified then the manual probing tool is activated - see the MANUAL_PROBE command above for details on the additional commands available while this tool is active. The optional `HORIZONTAL_MOVE_Z` value overrides the -`horizontal_move_z` option specified in the config file. +`horizontal_move_z` option specified in the config file. If ADAPTIVE=1 is +specified then the objects defined by the Gcode file being printed will be used +to define the probed area. The optional `ADAPTIVE_MARGIN` value overrides the +`adaptive_margin` option specified in the config file. #### BED_MESH_OUTPUT `BED_MESH_OUTPUT PGP=[<0:1>]`: This command outputs the current probed