diff --git a/config/generic-printrboard.cfg b/config/generic-printrboard.cfg
index 9552a766..24814864 100644
--- a/config/generic-printrboard.cfg
+++ b/config/generic-printrboard.cfg
@@ -2,9 +2,12 @@
 # through D). To use this config the firmware should be compiled for
 # the AVR at90usb1286.
 
-# Note that the "make flash" command is unlikely to work on the
-# Printrboard. See the RepRap Printrboard wiki page for instructions
-# on flashing.
+# Note that the "make flash" command will not work for Printrboard!
+# To flash:
+# - Connect the "BOOT" jumper.
+# - Press the reset button (on board) to enter into DFU mode.
+# - Connect via USB and run:
+# avrdude -c flip1 -p usb1286 -U flash:w:out/klipper.elf.hex
 
 # See the example.cfg file for a description of available parameters.