config: Consolidate description of heater parameters in example.cfg

Describe max_delta in [heater] instead of in [heater_bed].

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This commit is contained in:
Kevin O'Connor 2020-07-25 11:50:57 -04:00
parent db05938a5f
commit 8ecec4be8e
1 changed files with 8 additions and 8 deletions

View File

@ -96,8 +96,7 @@ position_max: 200
# The extruder section is used to describe both the stepper
# controlling the printer extruder and the heater parameters for the
# nozzle. The stepper configuration has the same settings as the
# stepper_x section and the heater configuration has the same settings
# as the heater_bed section (described below).
# stepper_x section.
[extruder]
step_pin: ar26
dir_pin: ar28
@ -193,6 +192,11 @@ pid_Kd: 114
#pid_integral_max:
# The maximum "windup" the integral term may accumulate. The default
# is to use the same value as max_power.
#max_delta: 2.0
# On 'watermark' controlled heaters this is the number of degrees in
# Celsius above the target temperature before disabling the heater
# as well as the number of degrees below the target before
# re-enabling the heater. The default is 2 degrees Celsius.
#pwm_cycle_time: 0.100
# Time in seconds for each software PWM cycle of the heater. It is
# not recommended to set this unless there is an electrical
@ -213,17 +217,13 @@ max_temp: 210
# error. These parameters must be provided.
# The heater_bed section describes a heated bed (if present - omit
# section if not present).
# section if not present). It uses the same heater settings described
# in the extruder section.
[heater_bed]
heater_pin: ar8
sensor_type: EPCOS 100K B57560G104F
sensor_pin: analog14
control: watermark
#max_delta: 2.0
# On 'watermark' controlled heaters this is the number of degrees in
# Celsius above the target temperature before disabling the heater
# as well as the number of degrees below the target before
# re-enabling the heater. The default is 2 degrees Celsius.
min_temp: 0
max_temp: 110