From 8e5d228555fa122f706657ef51eec8582c3a55f3 Mon Sep 17 00:00:00 2001 From: Cymen Vig Date: Fri, 12 Jan 2018 23:59:57 -0500 Subject: [PATCH] Add a CR-10S configuration file. Signed-off-by: Cymen Vig Signed-off-by: Kevin O'Connor --- config/creality-cr10s-2017.cfg | 75 ++++++++++++++++++++++++++++++++++ 1 file changed, 75 insertions(+) create mode 100644 config/creality-cr10s-2017.cfg diff --git a/config/creality-cr10s-2017.cfg b/config/creality-cr10s-2017.cfg new file mode 100644 index 00000000..b2b74b20 --- /dev/null +++ b/config/creality-cr10s-2017.cfg @@ -0,0 +1,75 @@ +# This file contains pin mappings for the 2017 Creality CR-10S. To use +# this config, the firmware should be compiled for the AVR atmega2560. + +# See the example.cfg file for a description of available parameters. + +[stepper_x] +step_pin: ar54 +dir_pin: ar55 +enable_pin: !ar38 +step_distance: .0125 +endstop_pin: ^ar3 +position_endstop: 0 +position_max: 300 +homing_speed: 50 + +[stepper_y] +step_pin: ar60 +dir_pin: ar61 +enable_pin: !ar56 +step_distance: .0125 +endstop_pin: ^ar14 +position_endstop: 0 +position_max: 300 +homing_speed: 50 + +[stepper_z] +step_pin: ar46 +dir_pin: !ar48 +enable_pin: !ar62 +step_distance: .0025 +endstop_pin: ^ar18 +position_endstop: 0.5 +position_max: 200 + +[extruder] +step_pin: ar26 +dir_pin: ar28 +enable_pin: !ar24 +step_distance: .010526 +nozzle_diameter: 0.400 +filament_diameter: 1.750 +heater_pin: ar10 +sensor_type: EPCOS 100K B57560G104F +sensor_pin: analog13 +control: pid +pid_Kp: 22.2 +pid_Ki: 1.08 +pid_Kd: 114 +min_temp: 0 +max_temp: 250 + +[heater_bed] +heater_pin: ar8 +sensor_type: EPCOS 100K B57560G104F +sensor_pin: analog14 +control: pid +pid_Kp: 690.34 +pid_Ki: 111.47 +pid_Kd: 1068.83 +min_temp: 0 +max_temp: 130 + +[fan] +pin: ar9 + +[mcu] +serial: /dev/ttyUSB0 +pin_map: arduino + +[printer] +kinematics: cartesian +max_velocity: 300 +max_accel: 3000 +max_z_velocity: 5 +max_z_accel: 100