diff --git a/config/example-extras.cfg b/config/example-extras.cfg
index d7410ece..1ff7c10b 100644
--- a/config/example-extras.cfg
+++ b/config/example-extras.cfg
@@ -858,27 +858,6 @@
 #   chips. The defaults for each parameter are next to the parameter
 #   name in the above list.
 
-# BME280 two wire interface (I2C) environmental sensor.  Note that this
-# sensor is not intended for use with extruders and heater beds, but rather
-# for montitoring ambient temperature (C), pressure (hPa), and relative
-# humidity. See sample-macros.cfg for a gcode_macro that may be used to report
-# pressure and humidity in addition to temperature.
-#[temperature_sensor my_sensor]
-# See the "temperature_sensor" section below for a description of its
-# parameters. The parameters below describe BME280 sensor parameters.
-#sensor_type:
-#   Must be "BME280"
-#i2c_address:
-#  Default is 118 (0x76).  Some BME280 sensors have an address of 119 (0x77).
-#i2c_mcu:
-#  MCU the sensor is connected to.  Default is the primary mcu.
-#i2c_bus:
-#  The I2C bus the sensor is connected to.  On some MCU platforms the default
-#  is bus 0.  On platforms without bus 0 this parameter is required.
-#i2c_speed:
-#  The I2C speed (in Hz) to use when communicating with the sensor.  Default
-#  is 100000.  On some MCUs changing this value has no effect.
-
 # Common temperature amplifiers. The following parameters are
 # available in heater sections that use one of these sensors.
 #[extruder]
@@ -953,6 +932,27 @@
 #   pullup_resistor parameter (see example.cfg for details). At least
 #   two measurements must be provided.
 
+# BME280 two wire interface (I2C) environmental sensor.  Note that this
+# sensor is not intended for use with extruders and heater beds, but rather
+# for montitoring ambient temperature (C), pressure (hPa), and relative
+# humidity. See sample-macros.cfg for a gcode_macro that may be used to report
+# pressure and humidity in addition to temperature.
+#[temperature_sensor my_sensor]
+# See the "temperature_sensor" section below for a description of its
+# parameters. The parameters below describe BME280 sensor parameters.
+#sensor_type:
+#   Must be "BME280"
+#i2c_address:
+#  Default is 118 (0x76).  Some BME280 sensors have an address of 119 (0x77).
+#i2c_mcu:
+#  MCU the sensor is connected to.  Default is the primary mcu.
+#i2c_bus:
+#  The I2C bus the sensor is connected to.  On some MCU platforms the default
+#  is bus 0.  On platforms without bus 0 this parameter is required.
+#i2c_speed:
+#  The I2C speed (in Hz) to use when communicating with the sensor.  Default
+#  is 100000.  On some MCUs changing this value has no effect.
+
 # Generic heaters (one may define any number of sections with a
 # "heater_generic" prefix). These heaters behave similarly to standard
 # heaters (extruders, heated beds). Use the SET_HEATER_TEMPERATURE