From 85667649d1422e4b88f9137ffeae58898f66ea50 Mon Sep 17 00:00:00 2001 From: Yifei Ding Date: Sat, 20 Nov 2021 23:14:38 -0800 Subject: [PATCH] docs: beaglebone.md Caps and Code Fence Signed-off-by: Yifei Ding --- docs/beaglebone.md | 22 +++++++++++----------- 1 file changed, 11 insertions(+), 11 deletions(-) diff --git a/docs/beaglebone.md b/docs/beaglebone.md index 4ea3659c..67fc9657 100644 --- a/docs/beaglebone.md +++ b/docs/beaglebone.md @@ -11,9 +11,10 @@ image. One may run the image from either a micro-SD card or from builtin eMMC. If using the eMMC, install it to eMMC now by following the instructions from the above link. -Then ssh into the beaglebone machine (ssh debian@beaglebone -- -password is "temppwd") and install Klipper by running the following +Then ssh into the Beaglebone machine (`ssh debian@beaglebone` -- +password is `temppwd`) and install Klipper by running the following commands: + ``` git clone https://github.com/Klipper3d/klipper ./klipper/scripts/install-beaglebone.sh @@ -38,10 +39,10 @@ sudo update-rc.d octoprint defaults ``` It is necessary to modify OctoPrint's **/etc/default/octoprint** -configuration file. One must change the OCTOPRINT_USER user to -"debian", change NICELEVEL to 0, uncomment the BASEDIR, CONFIGFILE, -and DAEMON settings and change the references from "/home/pi/" to -"/home/debian/": +configuration file. One must change the `OCTOPRINT_USER` user to +`debian`, change `NICELEVEL` to `0`, uncomment the `BASEDIR`, `CONFIGFILE`, +and `DAEMON` settings and change the references from `/home/pi/` to +`/home/debian/`: ``` sudo nano /etc/default/octoprint ``` @@ -51,7 +52,7 @@ Then start the Octoprint service: sudo systemctl start octoprint ``` -Make sure the octoprint web server is accessible - it should be at: +Make sure the OctoPrint web server is accessible - it should be at: [http://beaglebone:5000/](http://beaglebone:5000/) ## Building the micro-controller code @@ -71,8 +72,7 @@ sudo service klipper start ``` It is also necessary to compile and install the micro-controller code -for a Linux host process. Run "make menuconfig" a second time and -configure it for a "Linux process": +for a Linux host process. Configure it a second time for a "Linux process": ``` make menuconfig ``` @@ -88,7 +88,7 @@ sudo service klipper start Complete the installation by configuring Klipper and Octoprint following the instructions in -[the main installation document](Installation.md#configuring-klipper). +the main [Installation](Installation.md#configuring-klipper) document. ## Printing on the Beaglebone @@ -96,5 +96,5 @@ Unfortunately, the Beaglebone processor can sometimes struggle to run OctoPrint well. Print stalls have been known to occur on complex prints (the printer may move faster than OctoPrint can send movement commands). If this occurs, consider using the "virtual_sdcard" feature -(see [config reference](Config_Reference.md#virtual_sdcard) for +(see [Config Reference](Config_Reference.md#virtual_sdcard) for details) to print directly from Klipper.