diff --git a/docs/FAQ.md b/docs/FAQ.md
index 3b0768a2..42485101 100644
--- a/docs/FAQ.md
+++ b/docs/FAQ.md
@@ -97,11 +97,17 @@ baud rate to 250000 when using Klipper.
 ### Can I run Klipper on something other than a Raspberry Pi 3?
 
 The recommended hardware is a Raspberry Pi 2 or a Raspberry
-Pi 3. Klipper will run on a Raspberry Pi 1 and on the Raspberry Pi
-Zero, but these boards don't have enough processing power to run
-OctoPrint well. It's not uncommon for print stalls to occur on these
-slower machines (the printer may move faster than OctoPrint can send
-movement commands).
+Pi 3.
+
+Klipper will run on a Raspberry Pi 1 and on the Raspberry Pi Zero, but
+these boards don't have enough processing power to run OctoPrint
+well. It's not uncommon for print stalls to occur on these slower
+machines (the printer may move faster than OctoPrint can send movement
+commands) when printing directly from OctoPrint. If you wish to run on
+one one of these slower boards anyway, consider using the
+"virtual_sdcard" feature (see
+[config/example-extras.cfg](../config/example-extras.cfg) for details)
+when printing.
 
 For running on the Beaglebone, see the
 [Beaglebone specific installation instructions](beaglebone.md).
diff --git a/docs/beaglebone.md b/docs/beaglebone.md
index 5d773287..93870c3f 100644
--- a/docs/beaglebone.md
+++ b/docs/beaglebone.md
@@ -54,7 +54,6 @@ sudo systemctl start octoprint
 Make sure the octoprint web server is accessible - it should be at:
 [http://beaglebone:5000/](http://beaglebone:5000/)
 
-
 Building the micro-controller code
 ==================================
 
@@ -92,3 +91,13 @@ Remaining configuration
 Complete the installation by configuring Klipper and Octoprint
 following the instructions in
 [the main installation document](Installation.md#configuring-klipper).
+
+Printing on the Beaglebone
+==========================
+
+Unfortunately, the Beaglebone processor can sometimes struggle to run
+OctoPrint well. Print stalls have been known to occur on complex
+prints (the printer may move faster than OctoPrint can send movement
+commands). If this occurs, consider using the "virtual_sdcard" feature
+(see [config/example-extras.cfg](../config/example-extras.cfg) for
+details) to print directly from Klipper.