config: Updates to printer-wanhao-duplicator-i3-v2.1-2017.cfg
Add lcd encoder pins. Add comment on 10K pullups. Signed-off-by: Carlos Felicio <cfeliciomobil@gmail.com> Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This commit is contained in:
parent
22132a5516
commit
79632878ac
|
@ -65,6 +65,12 @@
|
|||
# (like an upgraded hot end or a separate MOSFET for your heated bed), you may
|
||||
# want to increase these values.
|
||||
#
|
||||
# Note: Some Melzi boards were shipped with 10K pullup resistors
|
||||
# instead of 4.7K. If the temperatures on your printer seem way
|
||||
# off before running the PID tune, you may need to add
|
||||
# "pullup_resistor: 10000" to both the extruder and the heater_bed
|
||||
# config sections.
|
||||
#
|
||||
# * [mcu] > serial
|
||||
#
|
||||
# Enter the USB serial port of the printer in /dev/serial/by-id/ format
|
||||
|
@ -157,3 +163,5 @@ lcd_type: st7920
|
|||
cs_pin: PC1
|
||||
sclk_pin: PD3
|
||||
sid_pin: PC0
|
||||
encoder_pins: ^PA2, ^PA1
|
||||
click_pin: ^!PA3
|
||||
|
|
Loading…
Reference in New Issue