3diy
/
klipper
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity

docs: document changes to the virtual_sdcard module 

Signed-off-by:  Eric Callahan <arksine.code@gmail.com>
This commit is contained in:
Arksine 2020-07-31 18:10:31 -04:00 committed by KevinOConnor
parent 6b1ad715aa
commit 74c0e3a484
2 changed files with 11 additions and 0 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

6
docs/Config_Changes.md
View File

@ -6,6 +6,12 @@ All dates in this document are approximate.
# Changes # Changes
20200731: The behavior of the `progress` attribute reported by
the `virtual_sdcard` printer object has changed. Progress is no
longer reset to 0 when a print is paused. It will now always report
progress based on the internal file position, or 0 if no file is
currently loaded.
20200725: The servo `enable` config parameter and the SET_SERVO 20200725: The servo `enable` config parameter and the SET_SERVO
`ENABLE` parameter have been removed. Update any macros to use `ENABLE` parameter have been removed. Update any macros to use
`SET_SERVO SERVO=my_servo WIDTH=0` to disable a servo. `SET_SERVO SERVO=my_servo WIDTH=0` to disable a servo.

5
docs/G-Codes.md
View File

@ -60,6 +60,11 @@ Klipper also supports the following standard G-Code commands if the
- Set SD position: `M26 S<offset>` - Set SD position: `M26 S<offset>`
- Report SD print status: `M27` - Report SD print status: `M27`
In addition, the following extended commands are availble when the
"virtual_sdcard" config section is enabled.
- Load a file and start SD print: `SDCARD_PRINT_FILE FILENAME=<filename>`
- Unload file and clear SD state: `SDCARD_RESET_FILE`
## G-Code arcs ## G-Code arcs
The following standard G-Code commands are available if a "gcode_arcs" The following standard G-Code commands are available if a "gcode_arcs"