From 7290c14531211d027b430f36db5645ce496be900 Mon Sep 17 00:00:00 2001 From: Apulo Date: Thu, 6 Oct 2022 11:16:13 -0400 Subject: [PATCH] config: Update generic-th3d-ezboard-lite-v2.0.cfg (#5785) Corrected the build instructions for the TH3D EZBoard V2 to include the command to convert Klipper.elf to a SREC bin format named firmware.bin. The SREC format is required for the bootloader installed on the board. Signed-off-by: Anthony Dellett --- config/generic-th3d-ezboard-lite-v2.0.cfg | 13 ++++++++----- 1 file changed, 8 insertions(+), 5 deletions(-) diff --git a/config/generic-th3d-ezboard-lite-v2.0.cfg b/config/generic-th3d-ezboard-lite-v2.0.cfg index 70e553e4..731f48a2 100644 --- a/config/generic-th3d-ezboard-lite-v2.0.cfg +++ b/config/generic-th3d-ezboard-lite-v2.0.cfg @@ -1,11 +1,14 @@ # This file contains common pin mappings for the TH3D EZBoard Lite v2. -# To use this config, the firmware should be compiled for the -# STM32F405 with 12mhz Crystal, 48KiB Bootloader, and USB communication. +# To use this config, check "Enable extra low-level configuration options" +# and compile the firmware for the STM32F405 with 12mhz Crystal, +# 48KiB Bootloader, and USB communication. + +# After the firmware is compiled, execute the following command +# arm-none-eabi-objcopy -O srec out/klipper.elf out/firmware.bin # The "make flash" command does not work on this board. Instead, -# after running "make", copy the generated "out/klipper.bin" file to a -# file named "firmware.bin" on an SD card and then restart the board -# with that SD card. +# after running "make", copy the generated "out/firmware.bin" file to +# an SD card and then restart the board with that SD card. # See docs/Config_Reference.md for a description of parameters.